Rollac Zipshade Manual & Warranty

Operating Conditions

• Temperature: Operates between 0°F and 140°F (motor protected by thermal switch). Do not use in frost/ice.
• Humidity & Rain: 100% moisture resistant, but do not use in heavy rain, snow, or hail. Do not pressure wash.
• Wind: Meets Wind Class 3 (DIN EN 13561:2004), but retract shade in high winds. Always check forecasts.
• Obstacles: Keep the path clear of furniture, planters, branches, twigs, or leaves.

General Safety Precautions

• Only use ZipShade for its intended purpose.
• No climbing, standing, or hanging on the system.
• Do not insert hands or fingers into guide rails or moving parts.
• Keep children away from controls and moving sections.
• Any modifications require manufacturer’s written permission.
• Use only Rollac-approved components and replacement parts.

Electrical Safety (Motorized Units)

• Operates on 120V, 60Hz Somfy tubular motor.
• Controlled via remote or wall switch.
• Unplug or switch off breaker before maintenance.
• Allow 25 minutes cooldown if the motor overheats.
• Keep remotes out of children’s reach.
• Outdoor motor cables must be protected in conduit.
• Do not add unapproved sensors or accessories.

Stop operation and contact installer if:

• Motor makes unusual noises.
  
• Shade does not roll fully up or down.
• Motor housing is hot to the touch.
  

Automatic Controls (e.g., sun sensors):

 Turn off in frosty conditions, when unsupervised, or when away from home.

Manual Operation

• Rolling Down: Turn crank/rod counterclockwise until fully unrolled. Stop immediately if fabric loosens; reverse slightly to re-tension.
• Rolling Up: Turn clockwise until the bottom bar touches cassette. Do not force beyond the stop.
• Use steady, gentle pressure—avoid jerking or over-tightening.

Special Operation Notes

• Manual Tape or Crank Systems:
• Lower or raise gently, especially in the final third of travel.
• Keep crank handle at ~45° angle during operation.
• Do not force the crank if resistance occurs.

• Spring-Loaded Shutters:
• Unlock with key or slide locks before raising.
• Avoid slamming against the housing.
• Lock securely when shutter is fully closed

Maintenance & Care

• If fabric gets wet, unroll later to dry. Do not store wet longer than 3 days (prevents mold/spots).
• Clean with mild soap and warm water. Rinse thoroughly. Avoid abrasive cleaners or high-pressure sprays.
• Do not clean in direct sun to prevent streaking.
• For crystal window fabric: clean with lukewarm water only.
• Annually lubricate inner rails and moving parts with dry PTFE spray (never WD40).
• Inspect regularly for debris (leaves, twigs, nests) and remove promptly.
• Schedule an annual inspection with your installer.

Fabric & Hardware Notes

• Minor color differences, folds, or creases are normal and not covered by warranty.
• Crystal vinyl may show temporary milk stains or blue lines from moisture; these disappear when dry.
• Fabric may expand, shrink, or fade over time due to temperature and exposure.

Obstacle Detection Device (Optional)

• Stops motor if the shade meets an obstacle.
• To resume: press “up,” remove the obstacle, then operate normally.
• Important: This feature reduces risk but does not prevent all damage. Warranty does not cover impact damage from obstacles.

Important: If you notice abnormal noise, resistance, or malfunction, stop operation immediately and contact your authorized Rollac installer.

For more information about Rollac's Zipshade Manual & Warranty, click the link below.